Electrical
2 Pack, Large Blue Wing-Gard Screw On Wire Connector, Copper To Copper Connections On 14 To 6 AWG Wire Conbinations, 600V, UL Listed & CSA Approved, Carded.
25 Pack, Assorted Sizes Of Screw On Copper To Copper Wire Connectors, Contains 3 Small Gray, 4 Small Blue, 6 Orange, 6 Yellow & 2 Red, UL Listed, Bagged.
25 Pack, Green-Gard ScrewOn Grounding Connector, Use To Make Pigtail Grounding Connections With 14 & 12 AWG Copper Wire, UL Listed, Bagged.
1" Water Tight Cable Connector, For Service Entrance Cable Type 3#4, Use To Seal & Terminate Oval Type SE Or Type SEU Cable To A Threaded Entry Of A Watertight Enclosure.
100 Pack, 6", Black, Nylon Cable Tie, 45 LB Tensile Strength, Minimum Bundle Size 1/16", Maximum Bundle Size 1-3/8", Tie Width 0.14". UL Registered, Bagged.
2" Water Tight Cable Connector, For Service Entrance Cable Type 3#4/0, Use To Seal & Terminate Oval Type SE Or Type Seu Cable To A Threaded Entry Of A Watertight Enclosure.
3/4" Electrical Metallic Tubing Inside Corner Pull Elbow. Die Cast Zinc. Use To Facilitate Pulling Conductors Through A Sharp Bend In A Run Of Electrical Metallic Tubing In Dry Locations Where Obstructions Limit The Space Beyond The Connecor Such As Inside A Corner.
1/2" Galvanized Rigid Conduit Coupling, Use To Join 2 Lengths Of Threaded Rigid Or IMC Conduit, UL Listed. UPC Polybag. UPC Polybag.
3/4" Galvanized Rigid Conduit Coupling, Use To Join 2 Lengths Of Threaded Rigid Or IMC Conduit, UL Listed. UPC Polybag.
2 Pack 10 Amp Copper Clad Battery Clip, One With Red Insulated Grips, One With Black Insulated Grips, Carded.
1" Galvanized Rigid Conduit Coupling, Use To Join 2 Lengths Of Threaded Rigid Or IMC Conduit, UL Listed.
1/2" 90 Degree Rigid Conduit Elbow, Galvanized Steel, Use To Make A 90 Degree Change Of Direction In A Run Of Rigid Or IMC Conduit.
3/4" 90 Degree Rigid Conduit Elbow, Galvanized Steel, Use To Make A 90 Degree change of direction in A Run Of Rigid Or IMC Conduit.
1" 90 Degree Rigid Conduit Elbow, Galvanized Steel, Use To Make A 90 Degree change Of Direction In A Run Of Rigid Or IMC Conduit.
2 Pack, 12 AWG Stranded Copper Grounding Pigtail, Green Insulation, Grounding Screw Pre-Installed On One End, Opposing End Has A Spade Terminal, Carded.